Skip to content

FIREBLOCK® 2010/C

Intumescent paint for reinforced concrete / prestressed reinforced concrete structures and for not load-bearing partition walls in blocks of brick and concrete

It’s a water based intumescent paint. The product is certified for the protection of reinforced concrete/prestressed reinforced concrete structures in accordance with EN 13381-3 standard and of not load-bearing partition walls, in blocks of brick and concrete, in accordance with UNI EN 1363-1 and UNI EN 1364-1 standards.

Ciclo di applicazione

The application cycle provides the following procedures:

1) PREPARATION OF THE SURFACES

Check that the material to be protected is free of oily substances, grease, release agents which must be removed beforehand, and that the substrate is not already painted. Existing paint coats must be removed by sandblasting or by sandpapering.

2) PRIMER

Application of our product called PRIMER STARPLAST in the quantity of 100-150 g/m2 in order to improve the adhesion of the following coats of FIREBLOCK 2010/C.

3) INTUMESCENT PAINT

Application of several coats of intumescent paint called FIREBLOCK 2010/C with recoat time as specified in the relative technical data sheet. The dry film thicknesses and the quantities of FIREBLOCK 2010/C to be applied shall be determined by the engineering office of reference: they are based on the required fire resistance class and of the technical data, relating to the profiles to be painted, contained in report of calculation and in the drawings.

The FIREBLOCK 2010/C can be applied by brush or roller in the amount of 500 g/m2 per coat, or by spraying in the amount of 700 g/m2 per coat (dispositive airless without filter with nozzle from 31).

It’s important to take great care in the angled areas where the product tends to accumulate. Spray in this case at a distance of dispensing more high, reducing the scope of the gun.

4) TOPCOAT

When the FIREBLOCK 2010/C paint film is completely dry (after at least 2 days) the application procedure can be completed, if necessary, by applying our chlorinated rubber topcoat called STARGUM COLOR (semi-bright or bright version) designed to impart anti-weathering and water-resistant properties to the intumescent protection. The recommended quantity to apply in one coat is 150-200 g/m2 equivalent to a dry film thickness of approximately 60 micron.

Fire resistance test

Prima della prova

Durante la prova

Dopo la prova

CHIUSURA AZIENDALE FERIE ESTIVE 2020

VI INFORMIAMO CHE LA NOSTRA AZIENDA CHIUDERA’ PER IL PERIODO ESTIVO DAL 10/08/2020 AL 21/08/2020 COMPRESI.

COMPANY SUMMER HOLIDAYS 2020

 
WE INFORM YOU OUR COMPANY WILL BE CLOSED FOR SUMMER HOLIDAYS FROM 10/08/2020 TO 21/08/2020 INCLUSIVE.